|
GT2, GT3, RS and Cup Car Discussions Discussions on all topics related to all Porsche GT vehicles |
|
Thread Tools | Search this Thread | Display Modes |
|
#1
|
||||
|
||||
Re: PCCB wear on GT3 RS
The advice has spanned from tire sizing, moton set up, gearing, alignment etc
All stuff I would have figured out eventually on my own but if I can learn from others who have already done it, then that is all the better. IMHO, that is the absolute best part of these forums.
__________________
07 RS 11 3500 Denali Duramax |
#2
|
||||
|
||||
Re: PCCB wear on GT3 RS
If you intend to stick with the PCCB's then stick with the stock pad and just realize you're going to be changing pads more often. Keep an eye on the pad tapering even if you don't think you have a problem. You MUST inspect the pad wear by looking at the lower half of the pad regularly. Mine and every other PCCB track'd car I've seen has had tapered pad wear. Including at '10 GT3 that shared a garage with me at Mid Ohio this weekend. He's tracked his car a lot and came a fraction of an inch away from destroying a rotor due to severe tapering. There was a lot of pad looking at the top of the caliper and practically none on the bottom.
|
#3
|
||||
|
||||
Re: PCCB wear on GT3 RS
Quote:
|
|
|